Regency CS1200 用户手册

下载
页码 32
6
Regency CS1200 Freestanding Wood Stove
INSTALLATION
RESIDENTIAL 
INSTALLATION
1)
  Read all instructions before installing your Re-
gency Stove. Install and use only in accordance 
with these installation and operating instructions. 
Be aware that local Codes and Regulations may 
override some items in this manual. Check with 
your local inspector.
2)  Select a position for your Regency Stove. Consult 
the minimum clearance chart for your model and 
set the stove in place. For close clearance instal-
lation use listed double wall connector systems 
(refer to Combustible Wall Chimney Connector 
Pass - Throughs).
3)  To insure vertical alignment, suspend a plumb 
bob from the ceiling over the exact center of 
your stove fl ue and mark a spot on the ceiling to 
indicate the center of the chimney.
4)  Check that the area above the ceiling is clear for 
cutting. Re-confi rm the clearance from the stove 
to combustibles to insure that they are within the 
prescribed limits.
5)  Install chimney according to chimney manu-
facturers instructions. The performance of your 
woodstove is governed to a very large part by the 
chimney system. Too short a chimney can cause 
diffi cult start-up, dirty glass, backsmoking when 
door is open, and even reduced heat output. Too 
tall a chimney may prompt excessive draft which 
can result in very short burn times and excessive 
heat output. The use of an inexpensive fl ue pipe 
damper may be helpful in reducing excessive 
draft.
 CAUTION: The chimney should be the same size 
as the fl ue outlet on the stove. The chimney must 
be listed as suitable for use with solid fuels. For 
other types of chimneys check with your local build-
ing code offi cials. Do not confuse a chimney with a 
type “B” Venting System used for gas appliances 
as suitable for a wood burning appliance (refer to 
the Mobile Home installations section).
6)  Mark the location of the unit base on the fl oor, then 
move the stove aside and mark the position of the 
fl oor protector.
7)  The  fl oor protector must be of non-combustible 
material and must extend 16" in front of the door 
opening and 6" to the sides and rear of the unit.  
Some areas may require a larger size fl oor protector.  
See your local inspector.  For outside air installation 
refer to Mobile Home section.
8) When 
the 
fl oor protection is complete, position the 
stove with the fl ue collar centered under the installed 
chimney.
9)  In seismically active areas, Regency recommends 
that your unit is secured to the fl oor by using the 
bolt down holes inside the pedestal (the same ones 
used in Mobile Home installations).
10) For residential installations using "C" Vent (single 
wall) the chimney connector must be at least 24 
gauge steel. Do not use galvanized pipe. For Mobile 
Home installation refer to the Mobile Home instal-
lation section.
11)  Do not connect this unit to a chimney serving another 
appliance unless approved by your local building 
authority.
12)  A chimney connector cannot pass through an attic 
or roof space, closet or similar concealed space, 
or a fl oor, ceiling, wall or partition of combustible 
construction. In Canada, if passage through a wall, 
or partition of combustible construction is desired, 
the installation shall conform to CAN/CSA-B365, 
Installation Code for Solid-Fuel-Burning Appli-
ances and Equipment.
13) Your Regency Wood stove is not to be connected 
to any air distribution duct.
ROOM AIR 
IMPORTANT
Mobile home installations require the use of outside air.
See mobile home installation page for further details.
MODULAR INSTALLATION OPTIONS
Emissions from burning  wood or gas could 
contain chemicals known to the State of 
California to  cause cancer, birth defects or 
other reproductive harm.
NOTE: In Canada, fl oor protection must 
extend 18" to the front and 8" to 
each side of the stove.
OPTIONS: These can be installed at time of installation or added later:
Modular Option
Considerations when choosing options
Blower/Fan
Adding the blower will increase the area heated by the stove, it can move warm air beyond the room where the stove is installed. 
Ash Drawer Kit
Adding the Ash Drawer Kit makes cleaning ashes out of the stove easier and cleaner. 
Side Shields
Choice of black or stainless side shields.  One set of side shields must be installed on unit.
Ashlip
To help contain displaced ashes.