Lightolier 302MRIC9X 产品宣传页

Rev : 02

 

3 3/4" (95mm)

Accepts most 3 3/4" (95mm) 300 serie trims ; see Reflector
Trim specification sheets.

Mounting Frame: 20ga. galvanized steel. Four slots are positioned  90º

apart to simplify alignment.

20" (508mm) long. Set of 2

Insulated ceiling Housing: .018" galvanized steel. CSA certified
for direct contact with thermal insulation. Internal thermal cut-out insures against

overheating due to incorrect lamping.  

To lock mounting bars in place after installation. Set of 12.

Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend
to 27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail eliminates

the need of additional nailing. Attaches to wood joist or T-bar without need of

Polyvinyl Air Vapour Barrier ; to comply with provincial legislation. For all

accessories. 

non Air-Seal frame-In-Kits.

Mounting Bars Locking Clip: (1) locks mounting bars in place. Additional
clips are sold separately (0098 set of 12)

Socket :  Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
250º leads to junction box. 

Dimming controls: use only dimmers specifically designed for use with

Transformer: Magnetic 50VA, 120 volts primary, nominal 12 volts secondary, 

transformers, like Lightolier Onset, Sunrise series LV or VA dimmers, or any

class "H".  (integral thermal protector)

Lightolier Controls dimming system. Low voltage fixtures may produce audible

Junction Box: 4"(102mm) x 3"(76mm) x 2"(51mm) 18 ga. galvanized steel .

noise. Attention should be given for noise sensitive applications.

CSA/UL certified for maximum of  4 No. 12 ga. 90º C through branch circuit
conductors. Integral cable clamp permit attachment of  non metallic Loomex

without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers.

Damp or Wet location rated depending on trim used.

Lamp cover: Aluminum heat deflector for 50W MR16 / 37W MR16 IR or
ES/ESD16 dichroic lamps.

WE RESERVE THE RIGHT TO CHANGE DETAILS OF DESIGN,  MATERIALS AND FINISH, IN ANY WAY

THAT WILL NOT ALTER INSTALLED APPEARANCE OR REDUCE FUNCTION AND PERFORMANCE.