Lightolier IS:C3FTA 产品宣传页

 
 
 

Finished ceiling 

Fig. 3 

Fig. 2 

Border Edge 

Ring Lip 

Fig. 1 

 

NOTE: Photos shown here have the frame already 
installed. This is not required if there is access 
above the ceiling after the ceiling is finished. 
 
1. Using a hole-saw, cut a 3-5/8” hole in the desired 
location.  
2. Fig. 1 Bring Flush-mount RING to the ceiling line 
and install into ceiling by pushing the ring up into the 
ceiling while rotating clockwise, ensuring the LIP is 
flush to the ceiling line. 
3. With ring installed, prepare plaster/compound. Very 
little plaster/compound is needed to create a smooth 
transition. 
4. Fig. 2 Bring plaster/compound up to the ceiling line 
using the tool of choice. Starting at the outside of the 
BORDER EDGE, evenly build up the 
plaster/compound around the entire RING LIP 
perimeter. 
5. Feather the plaster/compound out away from the 
RING until the transition is smooth and acceptable. 
Sand away blemishes in the surface if necessary, prior 
to finishing. 
 
Note: The installed Reflector Trim will still rotate freely 
360+ degrees even after plaster/compound is 
installed. Additionally, the ring can be used on all 
ceiling thicknesses listed for each trim. 

 COMPANY

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.  

To assure full compliance with local codes and regulations, check with your local electrical inspector before 

installation.  To prevent electric shock, turn off electricity at fuse box before proceeding. 

® EVOLUTION: