Lightolier LSBW-1 产品宣传页

Job Information 

Type:

Job Name: 

Cat. No.: 

Lamp(s): 

Notes:

 

"JSQPSU3PBE 'BMM3JWFS ."t t'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt

Lighting Systems

1BHFPG

-ZUFTQSFBEÜ-4#4PMJE8BMM.PVOU-JHIU51FS'PPU /PNJOBM 4FDUJPO

#

1. Housing: Extruded aluminum. Die-cast end cap mechanically attached with

no exposed fasteners or hardware.

2. Lamping: One T5, 28 or 54 watt (as specified) fluorescent lamp per 4-foot

nominal section. Provided by others.

3. Reflector: Precision die-formed, semi-specular aluminum.

Ballast - <10% T.H.D., .98 ballast factor, pre-heat start. 18 gauge wire. Color-
coded quick connectors allow ease of connection for joiner modules. For special
circuiting, consult factory. Factory installed ballast disconnect allows the ballast
to be disconnected from and reconnected to incoming power under load without
turning the entire circuit off.

Dimming - 120/277 VAC, 1% dimming level.

Emergency Battery Pack - 28 Watt: 520 Lumens @ 90 min.

54 Watt: 700 Lumens @ 90 min.

Individual Fixtures:
1. Order number of MODULES required.
2. Order one END SET per MODULE.

Continuous Rows:
1. Determine run length.
2. Order the appropriate number of MODULES to complete the run.
3. Order one END SET per run.

UL, cUL and I.B.E.W.

Complete ordering instructions below.

Type

Lamps

Length

Shielding

Ballast

Voltage

Finish

1 = 1-Lamp T5

4 = 4-Foot

A = Solid

28 = 28W T5

1 = 120 Volt

AL = Aluminum

8 = 8-Foot

54 = 54W T5

2 = 277 Volt

WH = White

5E = 54W T5 Emergency Pack
2E = 28W T5 Emergency Pack
5D = 54W T5 Dimming

Dual-screw, draw-tight connector to create hairline seam between joiner modules.

Powder coated baked white or aluminum finish. 
Custom colors available, consult factory.

11-3/8" (28.89cm)

8-1/2" (21.59cm)

1-3/4"

(4.45cm)

3-1/2" (8.89cm)