Cooper Lighting ADY071478 产品宣传页

1. To aim fixture, loosen both #10-32 x5/8" end screws. When

both indicators are lined up, the slope of the lens face is 40-
degrees. Each subsequent notch is an additional +/- 10-

degrees

2. When fixture head is rotated to desired angle, retighten end

screws to secure the position.

#10-32 x5/8"

End screw

Fixture head

indicator

Yoke arm

indicator

Warning

: Before starting any work ensure

that all sources of power are turned off. All

work must meet local/national codes and be
performed by a certified electrician. Do not

mount fixtures vertically.

Installation Instructions

Vault

C-Scroll

Roundel

These installation instructions are valid with the above Ametrix styles.

Sheet 1 of 2

Small, INDOOR

(Cantilever, Remote ballast)

Visor and Non-Visor

ADY071478 REV B (ECN80481)

Exploded View and part call-out

#8-32 x3/8"

Set screw

(2x)

Mounting

plate

Wiring the fixture

#10-32 x5/8"

End screw

(2x)

Fixture head

Attention:

All cantilever fixture assemblies require additional

bracing/structure around J-box to support fixture.

J-box

(by others)

Fasteners

(by others)

(4x)

#8-32 x3/8"

Set screw

(2x)

Securing the fixture to structure

1. Secure fixture head to pendant yoke using both #10-32 x5/8"

end screws.

2. Feed fixture wire through pendant tube.

3. Remove both #8-32 x3/8" set screws and slide canopy down

pendant.

4. Run wires from pendant and j-box through wiring holes in
mounting plate.

5. Use appropriate fasteners, secure mounting plate to structure

around J-box. Use additional bracing around J-box to

support fixture.

Aiming the fixture

Use additional bracing around
J-box to support fixture

Fixture

wire

Wiring holes

1. After securing fixture to structure, attach appropriate wires

and ensure connections are properly matched.

2. Push wire connections into J-box and cover mounting plate

with canopy.

3. Secure canopy with both #8-32-3/8" set screws.

#8-32-3/8"

Set screws

(2x)