Cooper Lighting ADY071468 产品宣传页
Set screws
#10-32 x3/8"
(2x)
Wiring the fixture
(8x)
Pan head screws
Canopy
(2x)
Sealing the fixture
#8-32 x3/8"
1/4-20 x2 3/4"
Hex bolt
Attention:
Dual fixture assemblies require additional bracing/structure
around J-box to support fixture.
Pan head screws
#8-32 x3/8"
Hex bolts
(x8)
(x2)
1/4-20 x2 3/4"
Cover plate
1. Slide fixture assembly onto pendant and secure with both 1/4-
20 x.2 3/4" hex bolts.
2. Remove cover plate on bottom of fixture assembly.
3. Attach appropriate wires and ensure all connections are
properly matched.
4. Secure cover plate with eight #8-32 x3/8" pan head screws.
Exploded view and part call-out
1/4-20 x 2 3/4"
Hex bolt
Securing Fixture to Ceiling
fixture
around J-box to support
(by others)
J-box
Set Screw
(2X)
(2X)
#10-32 x3/8"
Canopy
Use additional bracing
1/4" fasteners
(by others)
(4X)
1. Remove both 1/4-20 x 2 3/4" hex bolts from bottom of
pendant.
2. Remove both #10-32 x 3/8" set screws and allow canopy to
slide down pendant.
3. Run wires from J-box into pendant, ensure there is enough
3. Run wires from J-box into pendant, ensure there is enough
wire to reach cover plate on bottom of fixture assembly.
4. Using appropriate fasteners, secure fixture to ceiling. Use
additional bracing around J-box to support fixture.
5. Replace canopy and secure using both set screws.
5. Replace canopy and secure using both set screws.
3
Warning
2
that all sources of power are turned off. All
Sheet 1 of 2
performed by a certified electrician.
Visor and Non-Visor
: Before starting any work ensure
work must meet local/national codes and be
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
Small, OUTDOOR
P2R
(Pendant, 2-way, Remote ballast)
ADY071468 REV B(ECN80481)
Socket cap screw
(2x)
Socket cap screw
#6-32 x1/2"
#6-32 x5/8"
1. To seal fixture, ensure door is secured with provided socket
cap screws. Secure #6-32 x1/2" socket cap screws above door
latches.
latches.
2. Secure #6-32 x5/8" socket cap screw into center of door.
3. Refer to supplementary sheets for torque specs and aiming
instructions.