Chief Manufacturing CM2 用户手册
CM2
Installation Instructions
16
Extended Programming Capabilities
The CM2 allows for extended programming to make the mount
compatible with other devices such as a Universal Remote or
other control devices through a serial connection.
compatible with other devices such as a Universal Remote or
other control devices through a serial connection.
Setting or changing the configuration of the CM2 is done
through the remote control provided with the mount.
through the remote control provided with the mount.
The remote control has a range of 20-30ft (6-9m), and is
powered by 2 AAA batteries that are accessed from the back of
the remote.
powered by 2 AAA batteries that are accessed from the back of
the remote.
NOTE:
If operation of the mount is required at a greater
distance than remote control will allow, the mount can
be controlled through a hardwired switch or similar
divice. See Dry Contact Closures on page 24 and
(See figure 33) .
be controlled through a hardwired switch or similar
divice. See Dry Contact Closures on page 24 and
(See figure 33) .
The following table and illustration identify mount functionality
and response by button on the remote control(s).
and response by button on the remote control(s).
IMPORTANT ! :
Power must be provided to mount and IR
receiver must be installed in order to access extended
programming options.
programming options.
Normal Operating Mode
NOTE:
To restore mount to factory default settings, enter
setup mode and press the "PRESET III" button four
times.
times.
KEY
FUNCTION
REQUIRED ACTION
1
MOVE DISPLAY TO HOME
PRESS ONCE
2
EXTEND DISPLAY
PRESS AND HOLD
3
NOT USED
N/A
4
NOT USED
N/A
5
RETRACT DISPLAY
PRESS AND HOLD
6
PRESET POSITION 1
NOT USED
7
PRESET POSITION 2
NOT USED
8
PRESET POSITION 3
NOT USED
9
SAVE PRESET POSITION
NOT USED
10
STOP*
PRESS ONCE
Figure 29 Remote Control Function
MODEL: SC33A
MODEL: SE15
3
2
1
2
3
4
10
5
9
6
9
1
6
7
8
7
5
8
4