Sony SPM-TRI/C 用户手册

 

- 4 - 

42"

50"

 
 
 
 
 

 

 

         Phillips screwdriver                                    (4) M5 x 10 (mm) flat head Phillip screws  (4) Clear rubber feet  

                                                                    (6) M5 x 30 (mm) flat head Phillip screws  (2) M6 x 30 Phillips head screws (used on the 30” plasma only) 

                                                                    (2) M5 x 12 (mm) phillip security screws (used on 42" and 50" plasma displays only) 

                                                                    (2) #10 x 1-3/4" wood screws (Optional use)      

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Unpack the components from the box and set them on the floor. Invert and apply the four (4) clear rubber feet to the flat surface on the 

base, locate the four mounting points on the clear base. Secure the two (2) upright supports (flat surface facing out) to the base by using 
the four (6) M5 x 30 (mm) Phillip screws (supplied). CAUTION: Do not over tighten the screws.  

The stand fits a 32" 42" and 50" PFM series (Sony plasma displays only). The plate is stamped with two plasma sizes. Check the size that 

fits your plasma before installing. NOTE: If using a 32” plasma, the plate is not needed. Mount the plasma quick release sleeves from 

 The size and arrow must always point up prior to installation, finger tighten the (4) M5 x 10 (mm) phillips flat head screws then tighten the 
screws. See figure 2.  

 

Uprights 

Clear base 

(6) M5 x 30 

Flat head screws 

(4) M5 x 10 

Flat head screws 

Mounting plate