MartinLogan Home Theater System 用户手册

1

Mark a center point on the wall where you want to mount

the Script, 38 inches above the floor. This point is the

height recommended by MartinLogan to mount the Script

wall bracket and will be the location into which the

wall brackets upper mounting wall anchor and screw

are driven. You may choose to mount the Script higher or

lower—your seated ear level should be approximately

4 inches higher than the point that you just marked.

Make sure that the wall is clear of obstructions 6 inches to

the left and to the right of the center point, and from the

floor to 26 inches above the center point (see figure 3).

2

Use a hammer to tap a nylon wall anchor through the

center point and then drive the anchor all the way into

the wall by using a #2 Phillips bit and an electric drill

(see figure 3).

3

Mount the wall bracket to the wall by placing a #12 metal

washer on a screws and driving it through the hole at

the top-back of the wall bracket (the hole immediately

above the MartinLogan zig cutout) and into the center

point-mounting anchor. Do not tighten (see figure 3).

4

Allow the wall bracket to hang freely, and use a level to

assure the wall bracket is perfectly vertical (see figure 5).

Mark your second wall anchor location at the center of

the slot on the bottom-back of the wall bracket (the slot

immediately below the MartinLogan zig cutout). Pivot the

wall bracket to one side so that you can sink the wall

anchor into the location that you just marked. Use a

hammer to tap a nylon wall anchor through the center

point and then drive the anchor all the way into the wall

by using a #2 Phillips bit and an electric drill (see figure 4).

Mounting the Script On A Wall

Figure 3.

Figure 4.