Panasonic SKS-HT750 用户指南

 

En-

 

5

 

A mounting screw’s ability to support a speaker depends 
on how well it’s anchored to the wall. If you have hollow 
walls, screw each mounting screw into a stud. If there are 
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 3/8" or less and a 
shank diameter of 1/8" or less. With hollow walls, use a 
cable/pipe detector to check for any power cables or 
water pipes before making any holes.
Leave a gap of between 1/4" and 5/16" between the wall 
and the base of the screw head, as shown.

(We recommend that you consult a home installation 
professional.)

 

A

 

Red:

 Subwoofer in standby mode

Blue:

 Subwoofer on

With the Auto Standby function, the SKW-750 
automatically turns on when an input signal is 
detected in Standby mode. When there’s no input 
signal for a while, the SKW-750 automatically 
enters Standby mode.

 

B

 

This control is used to adjust the volume of the sub-
woofer.

 

C

 

This RCA input should be connected to the sub-
woofer pre out on your AV receiver, amp, or other 
receiver with supplied RCA cable.

 

The Auto Standby function turns the subwoofer on when 
the input signal exceeds a certain level. If the Auto 
Standby function does not work reliably, try slightly 
increasing or decreasing the subwoofer output level on 
your receiver or amp.

1/4"–5/16"

Wall

2

3

1

■ Rear

To AC outlet

■ Front

SKS-HT750_En,Fr,Es.book Page 5 Thursday, July 19, 2007 10:03 AM