Panasonic PT-DZ16KU 用户手册

Chapter 4 Settings — [PROJECTOR SETUP] menu

100 - ENGLISH

 

f

If the <ENTER> button is pressed when [LINK] is set from [GROUP A] to [GROUP D], the group name is displayed on the screens of 

projectors that have been set in the same group.

 

f

When [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], keep the shutter open for at least two minutes to perform the 

brightness sensor calibration after completed the [BRIGHTNESS CONTROL SETUP] setting.

 

f

If the shutter is closed within approximately 10 minutes after the lamp has turned on while [MODE] in [BRIGHTNESS CONTROL SETUP] is 

set to [AUTO] or [PC], brightness and color cannot be measured. Therefore, brightness may be corrected approximately two minutes after 

the shutter opens.

 

f

When [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] or [PC], the lamp brightness and color are automatically measured 

eight minutes after the lamp is turned on, and correction is performed so that the image brightness and color will be the same as the 

standard brightness and color at the time the brightness control are adjusted. Brightness and color of the lamp cannot be measured for eight 

minutes after the lamp has turned on because they are not steady.

 

f

If the lamp has gone off or lamp relay is performed while two or more lamps are selected to be lit in [LAMP SELECT] and [MODE] in 

[BRIGHTNESS CONTROL SETUP] is set to [AUTO], brightness and color are corrected to the extent possible approximately one minute 

later.

 

f

When [MODE] in [BRIGHTNESS CONTROL SETUP] is set to [AUTO] and [LINK] is set to [OFF], brightness will be corrected until it reaches 

the maximum amount of correction.

 

f

The variation in brightness may increase due to dust accumulating on the lens, screen, or inside the projector, depending on the installation 

environment of the projector.

 

f

Adjust brightness control again when lamp degradation causes increased variation in brightness or a lamp is replaced.

 

f

For continued use longer than 24 hours, set the [BRIGHTNESS CONTROL SETUP] to [CALIBRATION TIME], or set [LAMP RELAY]

(x page 97). If it is not set, correction will not be performed automatically.

 

f

Brightness control and dynamic iris operate simultaneously, but the iris is fully open and does not operate while brightness and color are 

measured.

 

f

The [CALIBRATION TIME] setting will be reflected at the time when you enter the time.

 

f

The [CALIBRATION MESSAGE] setting will be reflected at the time when items are switched using qw.

Display the brightness control status.

1)  Press as to select [BRIGHTNESS CONTROL].
2)  Press the <ENTER> button.

 

f

The 

[BRIGHTNESS CONTROL] screen is displayed.

3)  Press as to select [BRIGHTNESS CONTROL STATUS].
4)  Press the <ENTER> button.

 

f

The 

[BRIGHTNESS CONTROL STATUS] screen is displayed.

The screen shows the status that the brightness control is disabled.

The screen shows the status of the brightness control in one 

projector