Panasonic PT-DW17KU 用户手册
Switching on/off the projector
50 - ENGLISH
Basic Operation
Switching on the projector
Install the projection lens before switching on the
projector. (
page 43)
Remove the lens cover first.
1) Connect the power plug to an outlet.
(AC 200 V - 240 V 50 Hz/60 Hz)
2) Press the <ON> side of the <MAIN
POWER> switch to turn on the power.
▶
z
The power indicator <ON (G)/STANDBY (R)>
will light in red, and the projector will enter the
standby mode.
3) Press the power on < > button.
▶
z
The power indicator <ON (G)/STANDBY (R)>
will light in green and the image will soon be
projected on the screen.
Attention
z
Using the projector while the lens cover is attached
may cause the device to heat up and result in a fire.
Note
z
If the projector is switched on at about 0°C (32°F),
a warm-up period of approximately five minutes
may be necessary until a projection is displayed.
The temperature indicator <TEMP> is lit during the
warm-up period. When the warm-up is completed,
the temperature indicator <TEMP> turns off and the
projection starts. Refer to “Managing the indicated
problems” (
page 142) for the indicator status.
z
If the operating environment temperature is low and
warm-up takes more than 5 minutes, the projector
will judge that a problem has occurred and the
power will automatically be set to stand-by. If this
happens, increase the operating environment
temperature 0°C (32°F) or higher, turn off the main
power, and then turn on the power again.
z
If the menu [PROJECTOR SETUP] → [STANDBY
MODE] (
page 106) is set in the [ECO] menu,
display will start approximately 10 seconds later
compared to when [NORMAL] is selected.
Making adjustments and
selections
It is recommended that images are projected
continuously for at least 30 minutes before the focus
is adjusted.
4) Press the <FOCUS> button to roughly
adjust the focus of the image.
(
page 52)
5) Set the projection method using
[PROJECTION METHOD] (
page 99)
and [COOLING CONDITION] (
page 100)
on the menu.
▶
z
Refer to “Navigating through the menu”
(
page 61) for the operation of the menu
screen.
6) Press the input selection (<RGB1>,
<RGB2>, <DVI-D>, <VIDEO>, <HDMI>,
<SDI 1/2>) buttons to select the input
signal. (
page 58)
(SDI input is only PT-DZ21KU, PT-DS20KU)
7) Adjust the front and back, and sideway
tilt of the projector with the adjustable
feet. (
page 42)
8) Press the <SHIFT> button to adjust the
position of the image.(
page 52)
9) If the input signal is RGB, press the
<AUTO SETUP> button. (
page 59)
10) Press the <ZOOM> button to adjust
the size of the image to match the
screen. (
page 52)
11) Press the <FOCUS> button again to
adjust the focus.
12) Press the <ZOOM> button again to
adjust the zoom and the size of the
image to match the screen.
7)
6)
9)
3)
3)
5)
5)
4)
9)
6)
8)
10) 12)
4) 11)
8) 10) 11) 12)
2)
1)