Mitsumi electronic 738 Series 用户手册
5. NetCommand IR Control (838 Series)
65
For assistance call 1(800) 332-2119
Operating NetCommand-Controlled
Devices
Devices
Controlling Most Device Types
As an example of NetCommand control, if you are
watching your cable box and you wish to tune to the
next channel higher, press
watching your cable box and you wish to tune to the
next channel higher, press
CHANNEL UP. NetCommand
then sends the “learned” channel-up control signal to
the cable box.
the cable box.
Perform NetCommand setup for the device as
1.
described in this chapter.
When you wish to use the device, press
When you wish to use the device, press
2.
INPUT.
Highlight the icon for the device.
3.
Press
4.
ENTER to switch the TV to the device.
Note: if you have set up automatic input switching for
the A/V receiver, the A/V receiver will automati-
cally switch to the correct input for the device.
cally switch to the correct input for the device.
To operate the device using the
5.
TV’s remote
control, press the
TV key to put the remote control
into TV mode.
Point the remote control at the
Point the remote control at the
6.
TV (not the device)
and press the key for the desired function.
Press the
Press the
7.
TOOLS key to access additional key func-
tions you may have “learned” for the device.
After performing initial setup, you can add or remove
individual keys under NetCommand control.
individual keys under NetCommand control.
Switch the TV to the device. Press
1.
INPUT, highlight
the device’s icon, and press
ENTER.
Open the
2.
Inputs menu and highlight the Learn icon.
When the
3.
Learn screen displays:
To add keys:
•
Continue as described earlier
under
.
To delete keys:
•
Highlight the name of the key
you wish to delete and press
CANCEL on the
TV‘s remote control. Clears the check mark.
NetCommand Setup, continued
Adding or Removing Device Keys from
NetCommand Control
NetCommand Control
Special Operation Methods
Key Name in
Learning Screen
Learning Screen
Special Operation Description and Setup
How to Use
Power On
Manual Power On/Off
Use for devices that have only one
Use for devices that have only one
POWER key.
Press
1.
INPUT.
Highlight the icon for the device to be
2.
powered on or off.
With the
With the
3.
Input Selection menu still dis-
played, press
POWER to send the power
signal; you may need to press
POWER twice.
Note: If you press POWER without the Input Se-
lection menu displayed, the TV will turn
off.
off.
Press
4.
ENTER to switch the TV to the device.
Power On
Power Off
Automatic Power On/Off
This feature is only for devices that have separate
POWER ON and POWER OFF keys on their original
remote controls. If your device does not have a
separate
This feature is only for devices that have separate
POWER ON and POWER OFF keys on their original
remote controls. If your device does not have a
separate
POWER OFF key, do not use the Power
Off learning position; use only the Manual Power
ON/OFF method described above.
In the NetCommand
ON/OFF method described above.
In the NetCommand
Learn screen:
a. “Learn” the
Power On command in the
Power On learning position.
b. “Learn” the
Power Off command in the
Power Off learning position.
To Power On the Device
•
Press
1.
INPUT.
Highlight the icon for the device to be
2.
powered on or off.
Press
Press
3.
ENTER to switch the TV to the
device and NetCommand will send the
Power On command to the device.
Power On command to the device.
To Power Off the Device
•
When you turn the TV off, the TV sends all
learned
learned
Power Off commands to all devices.