Runco SC-35d 用户手册

• E-Mail Notification: Select E-Mail Notification from the Network menu to specify 

when and to whom the Dimension Digital Controller sends error and service notification 
messages via e-mail.

The notification messages are in the following format:

To:  [E-Mail Address; see below]
From:  do-not-reply@runco.com
Subject:  [Type of notification] from Runco DC-300
Body:  

This is an automated message sent from the Runco DC-300:

Notification:

[One of the following:
“DC-300 Error” / “Display Error” 
“Periodic Service Notification”
“Lamp Life Notification” / “Calibration Data”]

Detailed Description: [ If a DC-300 Error, one of the following:

“Fan Failure 1” / “Fan Failure 2”
“Overtemp 1” / “Overtemp 2”
“Initialization Failure”

If a Display Error, a device-specific 
error message such as “Lamp Door Open”

If a Periodic Service Notification, the elapsed
time since the last notification

If a Lamp Life Notification, the number of hours 
the lamp has been in service

If a Calibration Data message, 
“See Attached File” ]

Serial Number:

[Dimension Digital Controller serial number]

Customer Information: [From “Customer Information“ sub-menu; 

see below]

Best Regards,

Runco International, LLC
1195 NW Compton Drive
Beaverton, OR 97006
1-800-237-8262

• E-Mail Address: To specify the destination e-mail address for error and service 

notifications, select E-Mail Address from the E-Mail Notification menu. The 
procedure is similar to that for setting the IP address (refer to IP Configuration on 
page 90). Enter up to 45 alphanumeric characters. 

• Error Notification: To have the Dimension Digital Controller send a message to the 

destination e-mail address when a “DC-300 Error” or “Display Error” occurs, select 
Error Notification from the E-Mail Notification menu and set it to On. 

• Error Notification to Runco: To have the Dimension Digital Controller send an 

e-mail message to Runco Customer Support when a “DC-300 Error” or “Display 
Error” occurs, select Error Notification to Runco from the E-Mail Notification menu 
and set it to On.