Runco SC-35d 用户手册

Table 3-1 gives a quick overview of the SC-30d/SC-35d installation process. The sections 
following this one provide detailed instructions. 

Choose a location for the projector

Install primary projection lens 

Install anamorphic lens mounting assembly (optional)

30, 40

Mount the projector

Mount the Dimension Digital Controller 

Connect the Dimension Digital Controller to the projector

Connect other external equipment to Dimension Digital Controller 
(optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (retractable screens or 

screen masking)

• External IR repeater
• Network hub, router or gateway (Ethernet)

Connect signal sources to the Dimension Digital Controller

Connect the Active 3D Emitter to the Dimension Digital Controller

Connect system components to AC power 

Apply power to the projector 

Adjust primary lens: projected image size (zoom), position (shift) 
and focus

For rear-screen and/or ceiling-mount installations, select the 
proper picture orientation 

Use Image Alignment controls to fine-tune image geometry

Install and adjust secondary anamorphic lens (optional)

Display calibration: adjust the following for each Dimension 
Digital Controller input and display mode (resolution/frame 
rate); save settings when finished:
• Aspect ratio

• Color level

• Brightness

• Tint

• Contrast

• Input position

• Color temperature and white balance

64 through 83

Prepare Active 3D Glasses for use and test with 3D source mate-
rial