Runco SC-35d 用户手册
54
Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
“Keystoning” usually occurs when the projector is tilted relative to the screen. “Pincushion”
distortion can sometimes occur if the throw distance is very short and/or the projector is
equipped with an anamorphic lens.
distortion can sometimes occur if the throw distance is very short and/or the projector is
equipped with an anamorphic lens.
To correct keystoning or pincushion distortion:
1.
On the Dimension Digital Controller remote control or front panel, press MENU.
2.
Select Calibration from the Main Menu and enter the Calibration Menu passcode.
3.
Select Image Alignment from the Calibration Menu.
4.
Select Corner Alignment to correct a “keystoned” image by adjusting the image
corner positions. Select Midpoint Alignment to correct pincushion distortion by
adjusting the image edge mid-points. See Figure 3-28.
corner positions. Select Midpoint Alignment to correct pincushion distortion by
adjusting the image edge mid-points. See Figure 3-28.
Figure 3-28. Image Alignment Controls
You must enter a passcode to access the Calibration menu.
Use the built-in test pattern when adjusting the image corners or
midpoints. To access it, check the Test Pattern box in the Corner
Alignment or Midpoint Alignment menu.
midpoints. To access it, check the Test Pattern box in the Corner
Alignment or Midpoint Alignment menu.
Note
Tip
Top Left (x, y)
Left
Middle (x)
Left/Right
Middle (y)
Right
Middle
(x)
Middle
(x)
Bottom Left (x, y)
Top Right (x, y)
Bottom Right (x, y)
Top/Bottom Middle (x)
Top Middle (y)
Bottom Middle (y)
Notes:
1. Smaller “x” values move a point to the left; larger values move it to the right.
2. Smaller “y” values move a point up; larger values move it down.
1. Smaller “x” values move a point to the left; larger values move it to the right.
2. Smaller “y” values move a point up; larger values move it down.
Center
(x, y)