Runco SC-35d 用户手册
Runco SC-30d/SC-35d Installation/Operation Manual
1
PRE
L
IMINAR
1.1
About This Manual
About This Manual
This Owner’s Manual describes how to install, set up and operate the Runco
SC-30d/SC-35d Active 3D Projection System.
SC-30d/SC-35d Active 3D Projection System.
Throughout this manual, the Runco SC-30d/SC-35d Active 3D Projection System is
referred to as the “SC-30d/SC-35d.”
referred to as the “SC-30d/SC-35d.”
Target Audience
Runco has prepared this manual to help installation personnel and end users get the most
out of the SC-30d/SC-35d.
out of the SC-30d/SC-35d.
If You Have Comments
About This Manual...
About This Manual...
Textual and Graphic
Conventions
Conventions
Text Conventions: The following conventions are used in this manual, in order to clarify
the information and instructions provided:
the information and instructions provided:
• Remote and built-in keypad button identifiers are set in upper-case bold type; for
example, “Press EXIT to return to the previous menu.”
• Computer input (commands you type) and output (responses that appear on-screen) is
shown in monospace (fixed-width) type; for example: “To change the aspect ratio to
Letterbox, type
Letterbox, type
(ASP = 2) <Enter>.”
• All keys with functional names are initial-capped, set in bold type and enclosed in angle
brackets. These keys are the following:
<Enter>, <Spacebar>, <Control>,
<Esc> and <Tab>.
•
<Enter> indicates that you may press either the RETURN or ENTER key on your
keyboard if it has both keys.
keyboard if it has both keys.
In addition to these conventions, underlining, boldface and/or italics are occasionally used
to highlight important information, as in this example:
to highlight important information, as in this example:
1. Introduction
A carriage return must be used after each command or string.
Note