Runco LS-10D 用户手册
Runco LS-10d Installation/Operation Manual
39
PRE
L
IMINAR
Y
Connecting to AC Power
Projector/DHD Controller: Plug the female end of one power cord into the AC
receptacle on the rear of the LS-10d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
receptacle on the rear of the LS-10d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
Anamorphic Lens Transport: An
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
AC-to-DC power adapter is provided for
the lens transport. Connect the power
adapter to the +9V DC In jack on the
rear of the lens transport assembly.
Connect the other end to an AC power
source.
3.7
Turning on the Power
Turning on the Power
1.
Turn on your source components.
2.
Turn on the main power switch at the rear of the DHD Controller.
3.
Press the ON button on the remote control (or the ON/STANDBY (
) button on
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting LS-10d.”
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting LS-10d.”
4.
When the projector is ready for use, the fluorescent display indicates the active
source, input resolution/frame rate and aspect ratio; for example:
source, input resolution/frame rate and aspect ratio; for example:
HDMI
1
16:9 1080i/60
Current
Source
Aspect Ratio
Input Resolution/Frame Rate
LS-10d