Runco LS-100d 用户手册

Table 3-1 gives a quick overview of the LS-100d installation process. The sections 
following this one provide detailed instructions. 

Choose a location for the projector

Mount the projector

Connect the DHD Controller to the projector

Connect signal sources to the DHD Controller

Connect other external equipment to DHD Controller 
(optional):
• Audio processor or secondary display device
• Automation/control system (RS-232)
• 12-volt trigger-activated equipment 
• External IR repeater
• Network hub, router or gateway (Ethernet)

Connect projector and DHD Controller to AC power and 
power up

Adjust lens focus 

Select the proper picture orientation 

Use the Image Alignment controls to fine-tune image 
geometry

Display calibration: adjust the following for each input and 
display mode (resolution and frame rate); save settings 
when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Sharpness
• White Balance