Runco RS-900 Series RS1100 Series 用户指南

下载
页码 104
30
RS-900 and RS1100 Series Installation/Operation Manual
PRE
L
IMINAR
Y
1.
Place the projector upside down on a blanket or other soft surface.
2.
Install a nylon spacer (item #3) at each mounting hole location.
3.
Place the CineWide base plate (item #2) on the bottom of the projector. For a 
standard RS-900/CineWide or RS1100/CineWide, position the plate as shown in 
Figure 3-11; for an RS1100 Ultra/CineWide, position the plate as shown in Figure 
3-12. 
4.
If you are mounting the projector on a ceiling: Line up the four holes on the 
projector ceiling mounting plate (included with the projector ceiling mount kit) with 
those on the bottom of the projector and CineWide base plate.
5.
Secure the CineWide base plate (and ceiling mounting plate, if needed) to the 
projector with the M6x12mm screws (item #1) and nylon spacers provided with the 
CineWide lens base plate. 
 
3.5 
Mounting the 
RS-900/RS1100
There are several methods for mounting the projector. Depending on your chosen 
installation, one method may be more suitable than another. 
Floor Mounting (Upright)
In typical front and rear screen installations, the projector can be mounted to a secure and 
level surface such as a table or cart. Carts are useful when moving a projector during a 
presentation or from site to site. If possible, lock the wheels when it’s in position to prevent 
it from being moved during a presentation.
Ceiling Mounting 
(Inverted)
For fixed installations, and for those that want the projector out of sight or have a limited 
space for projector and audience, you can invert the RS-900/RS1100 and suspend it from 
the ceiling using a specially-designed ceiling mount fixture. 
 
The projector can also be inverted and placed in an enclosure above and behind the 
viewing area. Install four feet on the inside bottom surface of the enclosure on which the 
projector can rest. A variety of materials can be used for this purpose (for example, rubber 
crutch tips or turntable feet). 
Adjusting the Projector 
Height or Projection Angle
If the screen is significantly higher or lower than the projector, you can also tilt the 
projector at a slight angle. In a ceiling installation, you do this by adjusting the ceiling 
mount. 
1. Do not use the mounting screws provided with the ceiling 
mounting plate. Use only the hardware provided with the 
CineWide lens base plate. 
2. DO NOT OVER-TIGHTEN THE SCREWS. 
Caution
Use only the Runco-approved ceiling mount kit designed for your 
projector. Install the mount kit according to the instructions 
provided with it. 
Note