Runco RS-900 Series RS1100 Series 用户指南
56
RS-900 and RS1100 Series Installation/Operation Manual
PRE
L
IMINAR
Y
Sharpness: “Sharpness” is the amount of high-frequency detail in the image. To adjust
sharpness, select Sharpness from the Picture Adjust menu and press ENTER. On your
external test pattern source, select a pattern like the one shown in Figure 4-5. Adjust as
needed, looking for white edges around the transitions from black to gray and
differently-sized lines in the “sweep” patterns at the top and bottom. Lower the sharpness
setting to eliminate them.
sharpness, select Sharpness from the Picture Adjust menu and press ENTER. On your
external test pattern source, select a pattern like the one shown in Figure 4-5. Adjust as
needed, looking for white edges around the transitions from black to gray and
differently-sized lines in the “sweep” patterns at the top and bottom. Lower the sharpness
setting to eliminate them.
Figure 4-5. Typical Test Pattern for Adjusting Sharpness
Color Temperature: The RS-900/RS1100 has five memory settings for Color
Temperature:
Temperature:
• 5400 kelvins
• 6500 kelvins
• 9300 kelvins
• Custom 1
• Custom 2
Custom 1 and Custom 2 are installer-adjustable and can be used to create custom
settings. There are six (6) adjustable “white balance” parameters available for the Custom
1 and Custom 2 settings (two each for red, green and blue). These are described later in
this section; refer to White Balance on page 65.
settings. There are six (6) adjustable “white balance” parameters available for the Custom
1 and Custom 2 settings (two each for red, green and blue). These are described later in
this section; refer to White Balance on page 65.
Reset to Defaults: To reset all picture quality settings for the current input to their
factory-default values, select Reset to Defaults from the Picture Adjust menu.
factory-default values, select Reset to Defaults from the Picture Adjust menu.
Color Temperature
6500
You must enter a passcode to access the ISF menu.
Note