Runco SC-60D 用户手册
16
Signature Cinema™ SC-50d/SC-60d Installation/Operation Manual
PRE
L
IMINAR
Y
Notes on Remote Control
Operation
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the DHD Controller.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the DHD Controller, and repeat the operation.
3.2
Quick Setup
Quick Setup
Table 3-1 gives a quick overview of the SC-50d/SC-60d installation process. The sections
following this one provide detailed instructions.
following this one provide detailed instructions.
➤
Table 3-1. Installation Overview
Step
Procedure
For Details, Refer
to page...
1
Choose a location for the projector
2
Install primary projection lens
3
Install CineWide with AutoScope lens motor (optional)
4
Mount the projector
5
Connect the DHD Controller to the projector
6
Connect signal sources to the DHD Controller
7
Connect other external equipment to DHD Controller (optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (AutoScope lens motor,
• Audio processor or secondary display device
• Control system interface (RS-232)
• 12-volt trigger-activated equipment (AutoScope lens motor,
retractable screens or screen masking etc.)
• External IR repeater
• Network hub, router or gateway (Ethernet)
• Network hub, router or gateway (Ethernet)
8
Apply power to the projector
9
Adjust primary lens: projected image size (zoom), position (shift)
and focus
and focus
10
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation
proper picture orientation
11
Use Image Alignment controls to fine-tune image geometry
12
Install CineWide anamorphic lens (optional)
13
Adjust CineWide anamorphic lens: position, pitch (angle),
geometry and focus
geometry and focus
14
DHD Controller input calibration: adjust the following for each
DHD Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio
DHD Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio
• Color level
• Brightness
• Tint
• Contrast
• Input position
• Color temperature and white balance