Runco X-200i 用户手册
84
Runco X-200i Series Installation/Operation Manual
PRE
L
IMINAR
Y
Operations Commands: Operations commands allow more flexible and direct control of
the projector. The syntax for operations commands is as follows:
the projector. The syntax for operations commands is as follows:
op <operation> <command>[CR]
(Precede
<operation> and <command> with a space.)
The command type can be one of three functions:
Table 6-2 lists the valid operations commands. For Set and Get functions, the response
from the projector is
from the projector is
ACK: followed by the command and = <value> where <value> is
the current value or
ERR:NA if the value is not available. For Execute functions the
response is
ACK: followed by the command. All responses are in UPPERCASE.
Some operations command examples:
Input:
op bright ? [CR]
Response:
ACK:BRIGHT = 100 [CR]
Input:
op bright = 127 [CR]
Response:
ACK:BRIGHT = 127 [CR]
Input:
op resync [CR]
Response:
ACK:RESYNC [CR]
Input:
op input = 0 [CR]
0xB0
0xF0
Apply VIrtual Cinema aspect ratio to the
active source.
active source.
(none)
0xAC
0xEC
Toggles between power on and power off.
0xAD
0xED
Activates remote backlighting only when
pressed momentarily.
pressed momentarily.
0xB1
0xF1
Switch to 3D Auto mode.
0xB2
0xF2
Switch to 3D Side-by-side mode.
0xB3
0xF3
Switch to 3D Top-and-bottom mode.
Operations Control Commands
Function
Command
Action on unit
Set
= <value>
Makes the unit take that value.
Get
?
Asks what the current value is.
Execute
(none)
Performs an action such as a reset.
Table 6-1. Serial Command Key Names and IR Codes (continued)
RS232
Keyname
Remote
Button
IR Code
Description
Set 1
Set 2