Tascam SN29401376 用户手册

■

■

■

■

■

■

u functions don’t work

■

u

■

■

If you have a game console connected to the composite 
video input, and the picture isn’t very clear, you can 
attenuate the gain.
Video ATT :Off: (default).
Video ATT :On: Gain is reduced by 2 dB.
To make this setting, you must use the buttons on the 
AV receiver.
Press the input selector button for the source that you 
want to set, simultaneously with SETUP. Note that the 
input selector must be assigned to a composite video 
input. While holding down the input selector button, 
press SETUP until “Video ATT :On” appears on the 
AV receiver’s display. Then, release both buttons. To 
turn the setting off, repeat the above process so that 
“Video ATT :Off” appears on the AV receiver’s 
display, and release the buttons.

• With  the  USB input selector, this setting is only available when 

an iPod/iPhone is connected and set to Extended Mode (Video) 
or Standard Mode.

■

If the picture on your TV/monitor connected to 
the HDMI output(s) is unstable, try switching the 
DeepColor function off
To turn off the DeepColor function, simultaneously 
press the GAME and STANDBY/ON buttons on the 
AV receiver. While holding down GAME, press 
STANDBY/ON until “Deep Color:Off” appears on the 
AV receiver’s display. Then, release both buttons. To 
reactivate the DeepColor function, repeat the above 
process until “Deep Color:On” appears on the AV 
receiver’s display and release the buttons.

In the following cases, the power consumption in 
standby mode may reach up to a maximum of 8.3 W:

– The  “HDMI Control(RIHD)” setting is set to 

“On”. (Depending on the TV status, the AV 
receiver will enter standby mode as usual.)

– The  “HDMI Through” setting is set to other than 

“Off”.

– The  “Network Standby” setting is set to “On”.

60, 61, 
63

When a pair of headphones is connected, the listening 
mode is set to Stereo, unless it’s already set to Stereo, 
Mono, Direct, or Pure Audio (European models).

—

The values entered may be automatically adjusted 
with values best-suited for your home theater.

—

The display is turned off when the Pure Audio 
(European models) listening mode is selected.

—

Use the “Multiplex” setting in the “Audio Adjust” 
menu to select “Main” or “Sub”.

To use 

u, you must make an u connection and an 

analog audio connection (RCA) between the 
component and AV receiver, even if they are 
connected digitally.

While Zone 2 is selected, the 

u functions don’t 

work.

These functions don’t work when Zone 2 is turned 
on.

This can be caused by a malfunction in your speaker 
unit. Check if the unit produces normal sounds.

—

The AV receiver contains a microcomputer for signal 
processing and control functions. In very rare situations, 
severe interference, noise from an external source, or 
static electricity may cause it to lockup. In the unlikely 
event that this happens, unplug the power cord from the 
wall outlet, wait at least five seconds, and then plug it 
back in.

TEAC is not responsible for damages (such as CD rental 
fees) due to unsuccessful recordings caused by the unit’s 
malfunction. Before you record important data, make 
sure that the material will be recorded correctly.

Before disconnecting the power cord from the wall 
outlet, set the AV receiver to standby.