Shark EP600 用户手册

Pin

Hole

low

er

Always remove the power plug 

from the wall outlet before assembling or 

removing accessories.

• Push in the pin in the floor attachment 

as shown in the illustration at right.

• Insert the floor brush into its location, 

in the direction 

of the arrow.

• When inserted 

correctly, the 

pin will show in 

the pin hole.

• Press in the pin at the end of the 

hose (see illustration below).

• Insert the hose into its place (see 

arrow in illustration).

• When inserted correctly, the pin will 

show in the pin hole.

Pin Hole

• Push in the pin at the end of the lower 

piece of the metal handle (see 

illustration).

• Insert the metal handle into the hole

next to the handle.  Make sure that the 

slot in the handle fits correctly into the

opening. (See illustration.)

• When inserted correctly, the pin should 

rest in its hole.

• To wind the cord 

after usage, follow

the illustration below.

• To unwind the power 

cord, follow the 

illustration below 

but in the opposite 

direction.

• When using the vacuum, attach the 

cord to the cord holder so that the 

cord is out of the way when you are 

vacuuming. (See below.)

• Unwind the power cord and plug into 

the 120V outlet.

• Push down in the direction of the arrow 

to obtain best results on carpets or on 

hard wood floors.

When vacuuming 

deep pile carpets or 

hard to vacuum 

carpets, lower the 

angle of the 2-piece 

metal handle 

(see illustration at 

below) for 

easier 

maneuverability.  

• The On/Off switch has two different 

positions.

• Push on the "I" side to turn the 

vacuum ON.

• Push on the "O" side to turn the 

vacuum OFF.

For radiators, crevices, corners, 

baseboards and 

between cushions.

Dusting Brush
The dusting brush is used for the 
furniture, venetian blinds,
books, lamp shades 
and shelves.

• Hold the dust cup in your hand. 

• Turn it a complete 90° in the direction 

shown in drawing #1. (Turning less than 

90° will cause the dust cup to be 

attached on its bottom.)

• Let the dust cup come down slightly as 

shown in drawing #2.

• Slide the dust cup out towards you (see 

arrow in drawing #3).

• Hold the dust cup in your hand and 

remove the HEPA-Type dust cup filter 

(see drawing #4).

• Empty the dust cup (see drawing #5).

Always unplug the unit from 

electrical outlet before opening the Dust 

Cup (container).

• To insert the upper piece of the metal 

handle, press on the pin that is on the 

upper handle and insert into the lower 

handle making sure that the pin comes 

out of the pinhole on the lower handle.

• Disconnect the metal handle. 

(See page 4.)

• Disconnect the floor brush. 

(See page 4.)

• Attach the hose. (See page 4.)

• Attach the crevice tool or the dusting 

brush. (See below.)

• Attach the shoulder strap. 

(See page 7.)