Windsor SCC264 用户手册

CUTTER 24V   86039070   04/10/07 

 

1.  Choose a smooth, level surface.  Turn “ON” the 

key switch.  Lower the squeegee and drive 
forward at least 2 feet (60cm.). 

2.  With the squeegee down, stop the machine.  Do 

not allow machine to roll back. 

FOR SAFETY: Before leaving or servicing the 
machine; stop on level surface, turn off machine 
and remove key. 
3.  Determine the differences, if any, in deflection of 

the squeegee blade between each end and the 
middle.  Proper adjustment is obtained when 
deflection is equal all the way across the 
squeegee blade.   The bubble level should also 
indicate when the squeegee is adjusted 
properly.  When the air bubble is in the center of 
the vial, the deflection should be even across 
the squeegee blade. 

4.  To decrease the deflection of the squeegee 

blade at the ends, tighten knob near the 
squeegee center.  To increase the deflection at 
the ends of the squeegee assembly, loosen 
knob. 

5.  Check the deflection of the squeegee blades 

again.  Repeat steps 1 through 4 until the 
deflection is equal across the entire rear 
squeegee blade. 

 
 
 
 
 
 
 
 
 
 

 
1.  Choose a smooth, level surface.  Lower the 

squeegee and drive forward at least 2 feet 
(60cm). 

2.  With the squeegee down, stop the machine.  Do 

not allow machine to roll back. 

FOR SAFETY: Before leaving or servicing 
machine; stop on level surface, turn off machine 
and remove key. 
3.  Observe the amount of squeegee deflection.  It 

should deflect 3/8 in. (9.5mm) across the entire 
width of the squeegee. 

4.  To increase the squeegee deflection, turn the 2 

knobs at the squeegee ends counter-clockwise.  
To decrease the deflection, turn the knobs 
clockwise.   

NOTE: The  deflection should be consistent along 
the length of the squeegee.  If the deflection varies 
from end to end the knobs can be adjusted 
independently to correct the variation. 
5.  Turn on the key switch.  Raise, then lower 

squeegee assembly.  Drive forward at least 2 
feet (60cm). 

6.  Repeat steps 2 through 4 until deflection of 

 3/8 in. (9.5mm) is reached. 

 

  
These squeegee blades have two wear edges.  To 
use the second edge:  
 
1.  Remove deck shrouds. 
2.  Remove brushes or pad drivers. 
3.  Remove each of the Aqua-Mizer squeegee 

systems. 

4.  Remove the hardware from each system that 

retains the blade. 

5.  Flip the blades and replace hardware. 
6.  Re-install each Aqua-Mizer system, brushes or 

pad drivers and shrouds.