Windsor 10052410 用户手册

SCX364 86037150 1/17/07 

FOR SAFETY: Before leaving or servicing 
machine, stop on a level surface, turn off 
machine and set parking brake (If option is 
installed). 
 
1.  Remove front cover. 
2.  Remove clevis pin and rue ring from lower 

bracket of actuator; do not allow actuator barrel 
to rotate. 

3.  Disconnect actuator from wiring harness. 
4.  Remove upper clevis pin and rue ring from 

actuator bracket. 

5.  Reverse steps to install. 
 

 
The actuator will need to be adjusted when replaced.  
To adjust the actuator: 
 
1.  While holding actuator barrel to prevent it from 

spinning, apply power to the actuator such that it 
is fully extended. Positive power to white wire, 
and negative/ground to black.  Limit switch within 
actuator will stop it. 

2.  Turn barrel out one or more full turns to assure 

that when it is retracted it will not bind against 
itself. 

3.  While holding actuator barrel to prevent it from 

spinning, apply power to the actuator such that it 
is fully retracted.  Positive power to black wire, 
and negative/ground to white wire. Limit switch 
within actuator will stop it. 

4.  With actuator fully retracted, turn barrel in until it 

touches the base of the threaded shaft. 

5.  At the bottomed out position, turn the barrel out 

1 1/2 turns, then enough more to allow 
connection to lift linkage. 

6.  Connect actuator to lift linkage. 
7.  Check travel of actuator during operation. 

  

 
FOR SAFETY: Before leaving or servicing 
machine, stop on a level surface, turn off 
machine and set parking brake (If option is 
installed). 
 
1.  Remove front cover. 
2.  Swing the deck to the fully open position.  

This will align the access holes in the deck plates 
so that the clevis pin can be removed.   

3.  Remove the clevis pin and rue ring from both 

ends of the actuator. 

4.  Disconnect actuator from wiring harness. 
5.  Reverse steps to install. 
 

 
The actuator will need to be adjusted when replaced.  
To adjust the actuator: 
 
1.  While holding actuator barrel to prevent it from 

spinning, apply power to the actuator such that it 
is fully extended. Positive power to white wire, 
and negative/ground to black.  Limit switch within 
actuator will stop it. 

2.  Turn barrel out one or more full turns to assure 

that when it is retracted it will not bind against 
itself. 

3.  While holding actuator barrel to prevent it from 

spinning, apply power to the actuator such that it 
is fully retracted.  Positive power to black wire, 
and negative/ground to white wire. Limit switch 
within actuator will stop it. 

4.  With actuator fully retracted, turn barrel in until it 

touches the base of the threaded shaft. 

5.  At the bottomed out position, turn the barrel out 

1/2 of a turn, then enough more to allow 
connection to linkage. 

6.  Connect actuator to linkage. 
7.  Check travel of actuator during operation.