Ridgid WD1950 用户手册
Removing/Installing the Metal Handle
6
Your Metal handle comes packaged in
the carton in the reverse direction. You
must pull the metal handle completely out
of vac and reinstall the handle in the
correct direction, bent area facing away
from the back of the vac, before
continuing.
the carton in the reverse direction. You
must pull the metal handle completely out
of vac and reinstall the handle in the
correct direction, bent area facing away
from the back of the vac, before
continuing.
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
buttons indicates successful engagement
of handle.
Lowering Handle for Storage
To store Wet/Dry Vac, press and hold
release buttons while firmly sliding handle
down.
release buttons while firmly sliding handle
down.
Removing Handle
Press and hold release buttons, as
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
shown. While firmly pushing in release
buttons, pull handle upwards to remove
(see illustration).
Installing Tool Holder
Install tool holder as shown with
extension wand holders facing unit.
extension wand holders facing unit.
Correct
Position
Position
Storage
Position
Position
Moving
Position
Position
Metal Handle in
Reversed Position
(As Shipped)
Reversed Position
(As Shipped)
Tote Snaps
Tote
Straps (5)
Straps (5)
Handle
Extension
Wand
Storage
Locations
Wand
Storage
Locations
SP6567 16 Gallon Steel.qxd 8/15/07 1:32 PM Page 6