Riccar RCU-H7 用户手册

6

Installation

To use the air intake located on the right side 
of the vacuum: 

1.   Using a flat screwdriver, loosen the clamp 

collars and remove the rubber coupling 
from the left air intake 

(figure 4)..

2.   Unlatch the two clips and remove the dust  

receptacle (see page 17, 

figure 15).

3.   Remove the bag if needed for more  

 convenience (see page 17).

4.  Pull the bag adaptor out of the left air intake 

(figure 5).

5.   Remove the cap on the right air intake 

(figure 6) and put it on the left air intake.   

Making sure that the tabs are aligned with 
the notches, push the cap in completely 

.

6.   From the inside of the vacuum, insert 

the bag  adaptor into the right air intake, 
making sure that the  

embossed lines on the 

adaptor are aligned with the slots in the air 
intake 

. Outside the vacuum, the 

end of the adaptor should come out of the 
air intake about ¾" (1.9 cm).

7.  Put the rubber coupling on the right air 

intake and tighten the clamp collars using a 
flat screwdriver.

8.  Put the bag and dust receptacle back in  

place and latch both clips (see page 17).