Emerson IFT9701 用户手册

2

 continued

This Micro Motion product complies with all applicable European directives when properly installed 
in accordance with the instructions in this manual. Refer to the EC declaration of conformity for 
directives that apply to this product.

The EC declaration of conformity, with all applicable European directives, and the complete ATEX 
Installation Drawings and Instructions are available on the internet at www.micromotion.com/atex or 
through your local Micro Motion support center.

•

The term “sensor” refers to a Micro Motion sensor only.

•

The term “flowmeter” refers to an IFT9701 transmitter and a sensor installed as a 
flowmetering system.

The IFT9701 transmitter can be integrally mounted to a Micro Motion F-Series sensor, or remotely 
mounted from an ELITE

®

, F-Series, Model D, or Model DL sensor.

The IFT9701 transmitter does not operate with Micro Motion T-Series, R-Series, or Model D600 or 
DT sensors.

•

If the transmitter is integrally mounted to the sensor, the flowmeter includes the components 
shown in Figure 1-1.

•

If the transmitter will be remotely mounted from the sensor, the transmitter includes the 
components shown in Figure 1-2.

The transmitter is available with an optional liquid crystal display (LCD), as shown in Figure 1-1 and 
Figure 1-2, except for ATEX Zone 1 areas.

Field wiring compartment
With optional LCD

4X M8 mounting bolt
4X lock washer
4X flat washer
To rotate transmitter:
remove, then re-install to 
12 ft-lb (16 N-m) torque