Emerson IFT9701 用户手册

29

This chapter describes the flowmeter startup procedures, and provides basic information about 
transmitter behavior.

The Micro Motion Customer Service Department is available for assistance with flowmeter startup if 
you experience problems you cannot solve on your own.

If possible, provide us with the model numbers and/or serial numbers of your Micro Motion 
equipment, which will assist us in answering your questions. Phone numbers are listed on the title 
page of this manual.

Startup procedures include zeroing, which is required, and calibration, which may or may not be 
required.

After the flowmeter has been fully installed, you must perform the zeroing procedure. Flowmeter 
zeroing establishes flowmeter response to zero flow and sets a baseline for flow measurement.

To perform the zeroing procedure:

•

Using the flowmeter zero button, see Section 5.5

•

Using a HART Communicator, see Chapter 6

•

Using ProLink II software, see Chapter 7

•

Using AMS software, see the AMS on-line help

Calibration accounts for performance variations in individual meters and peripheral devices. For more 
information, see Section 5.6.

Zero the flowmeter before putting the meter in operation.