Rinnai V53I 用户手册
34
V53i & V53e Operation and Installation Manual
The conversion shall be carried out
by a manufacturer’s authorized rep-
resentative, in accordance with the
requirements of the manufacturer,
provincial or territorial authorities
having jurisdiction and in accordance
with the requirements of the CAN/
CGA-B149.1 or CAN/CGA-B149.2
Installation Codes / La conversion
sera exécuté par un représentant du
fabricant autorisé, conformément aux
conditions du fabricant, les autorités
provinciaux ou territoriaux ayant la
juridiction et conformément aux con-
ditions du CAN/CGA-B149.1 ou
CAN/CGA-B149.2 Codes d'Installa-
tion.
by a manufacturer’s authorized rep-
resentative, in accordance with the
requirements of the manufacturer,
provincial or territorial authorities
having jurisdiction and in accordance
with the requirements of the CAN/
CGA-B149.1 or CAN/CGA-B149.2
Installation Codes / La conversion
sera exécuté par un représentant du
fabricant autorisé, conformément aux
conditions du fabricant, les autorités
provinciaux ou territoriaux ayant la
juridiction et conformément aux con-
ditions du CAN/CGA-B149.1 ou
CAN/CGA-B149.2 Codes d'Installa-
tion.
switch
micro-
commutateur
micro-
commutateur
0-2000 ft
(0-610 m)
2001-4500 ft
(610-1372 m)
No 2
OFF
OFF
No 3
OFF
ON
Switch No.
F
O
F
8
5
7
6
4
3
ON
1
2
Switch No.
F
O
F
8
5
7
6
4
3
ON
1
2
Water Heater High Altitude Installation Setting Procedure
610 - 1372 m (2001 - 4500 ft) for Canada Only / Procédure Reglage
de Chaffeau á' Haute Altitude 610 - 1372 m (2001 - 4500 ft) pour
Canada Seulement
WARNING
DO NOT adjust the other
switches unless specifically
instructed to do so.
switches unless specifically
instructed to do so.
AVERTISSEMENT
NE modifiez PAS la disposition des
autres micro-commutateurs sauf sur
instructions spécifiques.
autres micro-commutateurs sauf sur
instructions spécifiques.
All settings/adjustments must be performed by a qualified
Service Technician / Tous reglages/ajustements doivent être exé-
cutés par un Technicien d'entretien qualifié.
1. Turn off the power source and gas supply to the water heater / Coupez l`alimentation de gaz et
électrique.
2. Remove the front cover from the water heater/ Enlever la couverture de devant du chauffe-eau.
3. Set the switches 2 and 3 to the values shown in the table below for your altitude. The default
setting for the appliance is 0-2000 ft (0-610 m) with switches No. 2 and No. 3 in the OFF posi-
tion / Régler les micro-commutateurs 2 et 3 aux valeurs montrées dans la table au dessous
pour votre altitude. Le reglage de défaut pour l'appareil est 0-2000 ft (0-610 m) avec les commu-
tateurs No 2 et No 3 sur la position OFF.
tion / Régler les micro-commutateurs 2 et 3 aux valeurs montrées dans la table au dessous
pour votre altitude. Le reglage de défaut pour l'appareil est 0-2000 ft (0-610 m) avec les commu-
tateurs No 2 et No 3 sur la position OFF.
4. Turn on the gas and power to the water heater / Ouvrez l`alimentatation de gaz et électrique.
5. Open a fixture or fixtures to flow water through the water heater at the maximum flow rate ob-
tainable (at least three gallons per minute) / Ouvrir un accessoire ou accessoires pour couler de
l'eau par le chauffe-eau au débit maximum procurable (au moins trois gallons par minute).
l'eau par le chauffe-eau au débit maximum procurable (au moins trois gallons par minute).
CANADA
ONL
Y