Rinnai R94LSe 用户手册

 

 

VA Series Outdoor LS Manual 

11 

 

1.  Press the “Water Smart / Bath Fill” 

button once.  The button will 
illuminate, a tone will sound, and 
the word “Bath” will appear next to 
the temperature setting. 

2.  The voice prompt will announce 

“The hot water system is ready.  
Open the hot water tap.” 
Open the hot water tap.  The “In 
Use” indicator will illuminate on all 
controllers.  The hot water will 
begin to flow.  

3.  When the preset volume of water 

has been produced then  

4.  Turn off the bath hot water tap and 

push the Bath Fill button.  The 
water heater will not allow hot 
water to flow from any source until 
the “Water Smart / Bath Fill” button 
is pushed. 
The button light will go out and the 
word “Bath” will disappear from the 
display. 

HOT

COLD

ON!

 

To stop the water flow during the Bath 
Fill function, press the “Water Smart / 
Bath Fill” button.  The button will flash 
and the voice prompt will announce, 
“Hot water is not available.  Turn off 
all hot water taps and push the Bath 
Fill button.”  Follow the voice prompt 
instructions. 

NOTICE 

the water flow will cease 

the “Water Smart / Bath Fill” 
button will flash 

a tone will sound 

the voice prompt will 
announce, “Bath fill is 
complete.  Turn off the bath 
hot water tap and push the 
Bath Fill button.” 

During the bath fill function, any hot 
water flowed at other locations, 
subtracts from the total amount of 
water for the bath.  For example if the 
bath fill function is set for 50 gallons 
and 5 gallons of hot water are used at 
other locations during the fill period 
then the bath will only fill with 45 
gallons. 

NOTICE 

HOT

COLD

ON!

  Using the Water Smart / Bath Fill Function

  Setting 

To eliminate the beeps when keys are pressed or to turn the beeps back on, press and hold both the 

and 

 

buttons until a beep is heard (approximately 5 seconds).