Rinnai R94LSe 用户手册

 

 

VA Series Outdoor LS Manual 

31 

  Remote 

1.  Determine a suitable location for the 

controller. 

2.  Make three holes in the wall as shown. 

3.  Run the cable between the controller and the 

Rinnai water heater or the controller and 
another controller. 

4.  Remove the face plate from the remote 

controller using a screw driver. 

5.  Connect the cable to the remote controller. 

6.  Mount the controller to the wall using the 

holes drilled in step 2. 

Do not attempt to connect the remote controllers with the power on.  There is 120 volt 
potential, next to the remote controller connections inside the unit.   

All service and wiring should be performed by a registered installer. 

     WARNING 

Outline of Remote

securing screw

1-21/32"

3-5/16"

securing screw

wiring hole

7.  Disconnect the power from the Rinnai water 

heater. 

8.  Remove the cover of the Rinnai water heater. 

9.  Remove the plastic cover from the PCB and 

electrical connections. 

10. Thread the cable through the access hole at 

the base of the unit and connect the wires to 
the controller terminals on the right hand side 
bottom of the PCB. 

11. Secure the controller cable using the clamp 

provided. 

12. Replace plastic cover over PCB and then 

replace the cover of the Rinnai water heater. 

Connecting to the R75LSe, R94LSe, R98LSe, and R98LSe-ASME 

CABLE CLAMP

REMOTE
CONTROL CABLE

REMOTE CONTROL
CONNECTION TERMINALS