Riccar R20D 用户手册

6

NOTE: Do not plug in the vacuum until it  
is completely assembled.

The vacuum cleaner and the handle are 
packed separately.
    
•  Remove the handle screw (Fig.1).  

Then position the handle behind the 
vacuum cleaner and level with the top of 
the unit. Hold the power cord down and 
away from the vacuum while the handle is 
being attached. Make sure that the switch 
on the handle is positioned toward the 
front of the vacuum cleaner.

•  On the bottom of the handle are two  

“T-shaped” rails that slide forward onto  
two guides located on the top of the 
vacuum cleaner. Line up the handle so  
that the “T-shaped” rails will slide into  
the guides and push the handle  
downward into the vacuum (Fig. 2).

•  Insert the handle screw and tighten  

securely (Fig. 3).

•  Remove the bag compartment cover to 

ensure a vacuum bag is in place. 

• Your vacuum is now ready for use.

•  If storing the vacuum, wrap the cord 

clockwise around the top and bottom cord 
hooks. Fasten the plug to the wrapped 
cord using the channel on the plug.

Fig. 1

Fig. 2

Fig. 3