Husqvarna C10 用户手册

22

Attention: Turn power switch to off (“O”) 
before inserting or removing the bobbin. 

When inserting or removing the bobbin, the 
needle must be fully raised.

1.  Remove the bobbin cover and insert the 

bobbin in the bobbin case with the thread 
running in a counterclockwise direction 
(arrow).

2.  Pull the thread through the slit (A).

3.  Pull the thread toward the left and along 

the inside of the spring until it slips into 
the notch (B) being sure that the thread 
does not slip out of the slit (A).

4.  Pull out about 15 cm (6 inches) of thread 

and slide on the bobbin cover. (C)