Garmin 521s 用户手册

Appendix

Track already Exists [Track Name]—you entered a saved track 

name that already exists in memory. Modify the track name or delete 

the existing track.
Track Log full—the track log is full and track recording has been 

turned off. To record more track points, you need to clear the track 

log and turn track recording on. This only appears when the track 

recording setting is set to “Stop When Full.”
Track Memory is full, Can’t Create Track—the track log 

memory is full. No additional track log data can be stored without 

deleting old data to create memory space.
Track Truncated—a complete uploaded track does not fit into 

memory. The oldest track log points were deleted to make space for 

the most recent data.
Transducer disconnected, Sonar Turned Off—there is not 

a transducer attached, there is a bad cable or transducer, or the 

transducer cable was disconnected. If the transducer cable is 

removed while the unit is on, reconnect and cycle power.
Transfer Complete—the unit has finished uploading or 

downloading information to the connected device.
User Card Not found, Please insert Card—attempted to transfer 

user data without an SD card containing user data being present in 

the SD card slot.

moved due to safe depth settings—the auto-guidance route was 

calculated but the starting and ending positions were moved because 

of safe depth settings.
water Speed Sensor is Not working—the speed sensor is not 

detected. Check the connections.
water Temperature alarm—sonar has reported a temperature 

above, below, inside, or outside the specified values.
waypoint already Exists—you entered a waypoint name that 

already exists in memory. Modify the waypoint name or delete the 

existing waypoint.
waypoint Memory full—you have used all 1,500 waypoints 

available. Delete unwanted waypoints to make space for new entries

You can capture a screenshot of any screen displayed on your unit as 

a bitmap (.BMP) file and then transfer it to your computer.

1.  Insert an SD card into the SD card slot on the front of the unit. 
2.  Select 

 > 

 > 

.

3.  Select 

 to turn screenshot captures 

.