Runco CW-95DHD 用户手册
CineWall™ Installer/Integrator Manual
33
PRE
L
IMINAR
Y
5.
Install the safety catches at the
top rear corners of the screen.
These prevent the screen from
separating from the hinge
when the screen is opened or
closed.
top rear corners of the screen.
These prevent the screen from
separating from the hinge
when the screen is opened or
closed.
a Remove the nut at one end
of the hinge wing on the
back of the screen.
back of the screen.
b Place the safety catch on
the exposed screw shaft
where you removed the nut.
where you removed the nut.
c Secure the catch using the nut that you removed in Step 5a.
4.4
Powering Up the
CineWall
Powering Up the
CineWall
Connecting the CineWall
to AC Power
to AC Power
Plug the female end of the power cord into the
AC receptacle on the right side of the CineWall
display engine, next to the power switch. Then,
connect the other end to your AC power
source (AC 100V ~ 240V).
AC receptacle on the right side of the CineWall
display engine, next to the power switch. Then,
connect the other end to your AC power
source (AC 100V ~ 240V).
1.
Set the main power switch (next to the AC receptacle) on the CineWall to the ON
position.
position.
2.
Return the strut to the closed position and close the screen.
3.
Gently press on the bottom left and right corners to engage the latches at the bottom
of the screen.
of the screen.
4.
Install two, AAA-size batteries (supplied) in the CineWall Setup remote control unit.
5.
Press the ON button on the CineWall Setup
remote control unit to turn on the display.
remote control unit to turn on the display.
Safety
Catch
Catch
Remove this nut,
install Safety Catch
and replace
install Safety Catch
and replace
Hinge Wing
ON
OFF
CPONENT
ANALOG
SVIDEO
HDMI
DVI
CPOSITE