Multiquip LS600P 用户手册

1.  Place the pump in the best location on the site to pump 

concrete efficiently.

2.  Lay down the hose in the shortest distance possible.

To reduce excessive vibration and rocking of the pump, set 

the rear stabilizers as follows:
1.  Locate both the left and right rear stabilizer jacks 

(Figure 16).

2.  Remove the cotter pin (Figure 17) from the handle tee 

bolt eye, and then pull the handle tee to release the 

stabilizer jack.

NeveR place feet under jack while operating.
ALWAYS retract rear stabilizer jacks prior to towing.
ALWAYS retract rear stabilizer jacks prior to servicing 

to relieve load (working pressure).

REAR

STABILIZER

JACKS

3.  Position both rear stabilizers jacks on firm (not loose) 

level ground (Figure 18).

4.  Align the hole on the stabilizer jack with the hole on 

the frame body and insert handle tee bolt.

5.  Insert the cotter pin into handle tee bolt eye to lock the 

stabilizer jack.

If your pump comes equipped with hydraulic rear stablizers 

(Figure 19), they can be controlled as follows: 
1.  Push down the middle control lever  to extend the right 

hydraulic rear stabilizer.

2.  Push up the middle control lever to retract the right 

hydraulic rear stabilizer.

3.  Push down the rightmost control lever to extend the 

left hydraulic rear stabilizer.

4.  Push up the rightmost control lever to retract the left 

hydraulic rear stabilizer.

INCORRECT

CORRECT

RIGHT HYDRAULIC

STABILIZER JACK

LEFT HYDRAULIC

STABILIZER JACK

MIDDLE CONTROL LEVER

(CONTROLS RIGHT

HYDRAULIC STABILIZER)

RIGHTMOST

CONTROL LEVER

(CONTROLS LEFT

HYDRAULIC

STABILIZER)