SPX Cooling Technologies TG MAG185-125 用户手册
56
R
L
X
8480
8350-C
8450
8430
8430
8450
8350-C
8350-A
8480
8470
A.0500.551 – IM-TGMAG/02.00 EN (02/2008)
4.3.2 Pre-assembly of the back-pull-out
4.3.2.1 Adjustment of the axial clearance of the
circulation pump
1. Place pump insert (8430) and radial bearing holder
(8350-C) in the intermediate cover (8450). Do not
use any shim (8470) at this stage.
use any shim (8470) at this stage.
Remark: There are two different inserts according to
the sense of rotation of the pump shaft (see sketch).
the sense of rotation of the pump shaft (see sketch).
2. Fit cap head screws (8480) and tighten them cross-
wise to fix the radial bearing holder (8350-C) and
insert (8430) to the intermediate cover (8450).
insert (8430) to the intermediate cover (8450).
3. Mount axial bearing (8350-A) into the insert (8430).
Do not use any force and be careful not to damage
the bearing faces while pushing part (8350-A) in until
the bearing faces are making contact.
the bearing faces while pushing part (8350-A) in until
the bearing faces are making contact.
4. Measure the distance between front face of the axial
bearing holder (8350-A)(front face gear tooth) and
the front face of the crescent of the pump insert
(8430).
the front face of the crescent of the pump insert
(8430).
5. Calculate the required thickness of the bearing
shim (8470): S = X – C.
Axial clearance C see table below.
Axial clearance C see table below.
TG MAG
Axial clearance C
[mm]
15-50
0.120 – 0.200
23-65
0.125 – 0.215
58-80
0.150 – 0.250
86-100
0.165 – 0.275
185-125
0.190 – 0.320