Sony MDS-E12 用户手册

7

1 ANALOG (BALANCE) input terminal (XLR type)

Inputs as an analog signal the sound of the component
connected by an XLR connecting cable.

2 OUTPUT LEVEL (BALANCE) selector

Changes the output level of the BALANCE.

3 ANALOG (BALANCE) output terminal (XLR type)

Outputs as an analog signal the contents of the MD of
this recorder to the component connected by an XLR
connecting cable.

4 ANALOG (UNBALANCE) input jacks

Inputs as an analog signal the sound of the component
connected by a pin type connecting cable.

5 ANALOG (UNBALANCE) output jacks

Outputs as an analog signal the contents of the MD of
this recorder to the component connected by a pin type
connecting cable.

6 ANALOG INPUT LEVEL control

Can adjust the level of analog input in a range of 

_

∞

 ~

+15 dB.
Normally, this control is used in the position (0 dB) of
center click.

7 DIGITAL COAXIAL input jack

Inputs as a digital signal the sound of the connected
component.

8 DIGITAL COAXIAL output jack

Outputs an a digital signal the contents of the MD of
the recorder to the connected component.

9 CONTROL-S jack

Connects the remote or control equipment.
If the plug is connected to the jack, the remote sensor
does not receive infrared rays.

0 PARALLEL connector

(D-sub 9-pin female)
Connects a component with simple circuits for the
remote operations of the functions preset in the
recorder.

!¡ RELAY OUT connector

!™ REELAY IN connector

Plays or records successively by connecting multiple
recorders and sending a control signal.

!£ RS-232C connector

(D-sub 9-pin male)
Connects a component that controls the recorder from
outside.

!¢ VOLTAGE SELECTOR

(Except for the USA/CA models.)
Select 120V or 230V according to the local power line
voltage. (Refer to page 2)

PUSH

PUSH

1

2

6

9

q;

qaqs

qd

7

8

3

45

qf