Panasonic WJ-HD716K 用户手册
75
Configure the event action at a VMD occurrence [VMD]
Select the [VMD] tab on the "Event" page. (+ Page 60)
The settings relating to event actions to be taken at a VMD (+ Operating Instructions (PDF)) occurrence can be configured on
this tab.
The settings relating to event actions to be taken at a VMD (+ Operating Instructions (PDF)) occurrence can be configured on
this tab.
[Operation Mode]
Select the settings for the operation mode. Refer to the
operating instructions (PDF) for further information about the
operation mode.
Select the settings for the operation mode. Refer to the
operating instructions (PDF) for further information about the
operation mode.
ADM (Activity Detection Mode): Performs only
recording and writing an event log at an event occur-
rence. Other event actions will not be performed.
rence. Other event actions will not be performed.
ALM (Alarm Mode): Performs every event action
according to the settings.
Off: Performs only writing an event log. Other event
actions will not be performed.
Configure the following settings for each camera channel (1
to 16).
to 16).
[Rec. cam.]
Select a camera channel (1 to 16) used for recording. When
"Off" is selected, recording will not be performed.
Select a camera channel (1 to 16) used for recording. When
"Off" is selected, recording will not be performed.
[Preset]
Select a preset position (1 to 256) to which the camera will
move at a VMD detection.
When the preset positions of two or more cameras have
been selected on the advanced setup page, "∗∗∗" is dis-
played and it is impossible to select the values.
Select a preset position (1 to 256) to which the camera will
move at a VMD detection.
When the preset positions of two or more cameras have
been selected on the advanced setup page, "∗∗∗" is dis-
played and it is impossible to select the values.
[Output terminal]
Select a terminal (TRM1 to TRM16) to output the alarm sig-
nal.
Select a terminal (TRM1 to TRM16) to output the alarm sig-
nal.