JVC KD-G116 用户手册

 

15

To prevent short circuits, we recommend that you disconnect the batteryʼs negative terminal and 

make all electrical connections before installing the receiver.

•  Be sure to ground this receiver to the car’s chassis again after installation.

•  Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC

car audio dealer.

•  It is recommended to connect to the speakers with maximum power of more than 50 W (both 

at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less 

than 50 W, change “AMP GAIN” setting to prevent the speakers  

from being damaged (see page 14 of the INSTRUCTIONS).

•  To prevent short-circuit, cover the terminals of the UNUSED  

leads with insulating tape.

•  The heat sink becomes very hot after use. Be  

careful not to touch it when removing this receiver.

Heat sink

2

  ENGLISH

 Check the wiring in the vehicle carefully. Incorrect connection may cause 

serious damage to this receiver.

The leads of the power cord and those of the connector from the car body may be different in 

color.

  Connect the colored leads of the power cord in the order specified in the illustration below.

  Connect the antenna cord.

  Finally connect the wiring harness to the receiver.

You can connect an amplifier to upgrade your car stereo system.

•  Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so 

that it can be controlled through this receiver.

•  Disconnect the speakers from this receiver, connect them to the amplifier. Leave the

Signal cord (not supplied for this receiver)

Front speakers

Rear speakers

Remote lead

Y-connector (not supplied for this receiver)

Remote lead (Blue with white stripe)

To the remote lead of other equipment or automatic antenna if any

*

2

  Before checking the operation of this receiver 

prior to installation, this lead must be connected, 

otherwise power cannot be turned on.

Line out (see diagram  )

Rear ground terminal

15 A fuse

Antenna terminal

Black

Blue with white stripe

Red

Yellow

*

2

*

1 

Not included for this receiver

To metallic body or chassis of the car

To a live terminal in the fuse block connecting to the car battery 

(bypassing the ignition switch) (constant 12 V)

Ignition switch

Fuse block

To an accessory terminal in the fuse block

To the automatic antenna if any (250 mA max.)

Left speaker (front)

Right speaker (front)

Left speaker (rear)

Right speaker (rear)

Purple

Purple with black stripe

Green

Green with black stripe

Gray

Gray with black stripe

White

White with black 

stripe

*

3

  Firmly attach the ground wire to 

the metallic body or to the chassis 

of the car—to the place not coated 

with paint (if coated with paint, 

remove the paint before attaching 

the wire). Failure to do so may 

cause damage to the receiver.

•  DO NOT connect the speaker leads of the power cord to 

•  BEFORE connecting the speaker leads of the power cord to the 

speakers, check the speaker wiring in your car.

To the remote lead of other equipment (200 mA max.)

Blue

KD-G116-008A.indd   2

10/16/04   12:21:04 PM