Kompernass KH 2262 用户手册

6

This section applies when the device has

been connected as described in chapter 3:

 The device is equipped with a 

FUNCTION sliding switch for all three

modes:

The device is switched on and is consu

ming electricity when the switch is 

switched to …

• "Radio" for radio mode

• "CD" for CD mode.

The device is switched off when the

switch is switched to position ...

• "TAPE/POWER OFF". This also the

position for tape mode. In this position,

the device consumes near to no 

electricity, as long as none of the tape

operating keys are pressed.

 Turn the volume control clockwise (lou-

der) - or anti clockwise (quieter).

 Press the BASS BOOST switch to 

activate or deactivate the Bass booster

function.

Select "Radio" on the  FUNCTION  sliding

switch.

 Chose a reception bandwidth. By pres-

sing the button  BAND  you can switch

between ...

• "FM" for VHF reception or

• "MW(AM)" for medium wave 

To search the bandwidth press the 

button ...
 TUNING , to search forwards or
 TUNING , to search backwards over 

the entire reception range.

If you apply pressure to the buttons lon-

ger than a second the device will start an

automatic channel search. As soon as a

channel with sufficient reception quality has

been found, the automatic search stops

immediately.

Tip: When in VHF reception (FM) mode,

you will achieve better reception quality by

putting the antenna into at an angle. Then

turn the antenna until the best reception is

found.

For medium wave (AM) reception, the

device uses the internal antenna. Turn the

entire appliance until you achieve the best

reception result.

When a program is broadcast on the VHF

range in stereo, "ST", is displayed on the

device, while "MONO" appears for Mono bro-

adcasts. Should the stereo reception crack-

le due to bad reception …
 press the  ST/MONO  button to switch

between the two modes.

You can store a total of 15 channels. When

you have found a channel you would like to

store ...
 press  MEMORY .The display shows the 

number of the first memory position, and

the"MEMORY" indicator flashes.

 You can now browse through the

memory positions by pressing the M-UP

button.

KH2262_LB4_UK_Ka  13.11.2003  14:04 Uhr  Seite 7