Moen T471 用户手册

Turn "OFF" both hot and cold water supplies, then open faucet to relieve pressure.  Remove handle cover from handle knob.  Take out handle screw and
remove handle knob, washer, and stop tube.  Lift out retainer clip.  Rotate cartridge shell back and forth with Moen cartridge twist wrench, grasp the cartridge
stem with pliers, and pull out the cartridge.

Re-insert cartridge by pushing it all the way into the body until the front of the ears on the cartridge shell are flush and aligned with the body,  (see illustration).
Replace the retainer clip so that the legs straddle the cartridge ears and slide down into the bottom slot in the body.  This prevents the cartridge from rotating
and locks it in the body.  The notched flat on the stem must point UP when mounting handle, with pointer UP.  Re-install stop tube, handle parts and handle
knob or lever.

IPS SPOUT:
CAUTION:  This spout is A.B.S. plastic and will crack when in contact with some pipe thread compounds.  Please read the pipe compound label to be certain.
We recommend using Teflon tape thread sealant.

Screw tub spout onto pipe and tighten by hand.  If final turn by wrench is needed, use small wrench with smooth jaws; otherwise, pad wrench teeth with rag
as shown.  DO NOT INSERT TOOL INTO SPOUT END TO TURN SPOUT. (Continued on last page).

SHOWER:  Install flange on long end of arm.  Wrap threads on both ends of shower
arm with Teflon tape.  Screw long end of shower arm into wall.  Install showerhead.

C.C. SPOUT:  The Moen Slip Fit spout is designed with an O-ring seal.  It is specifically
designed for installation with copper water tube.  Lookout must be free from burrs inside
and out.  The edge must not be rolled inward from a dull tubing cutter.  The outside
surface must be free from nicks and scratches.

Press and twist the spout onto the lookout upside down.  Tighten the clamp screw with
a 5/32" hex wrench until it just starts to bind.  Turn spout upright into position against
the wall and finish tightening the clamp screw by hand.  The use of pliers or another
wrench on the hex wrench is not necessary.  Do not overtighten.

Always turn water supply OFF before disassembly. Open faucet to alleviate sustained pressure.

1. Remove knob and escutcheon (pry off handle cap and remove handle screw).
2. Using snap ring pliers, remove retaining ring from valve body.
3. Grip stop valve stem with pliers and rotate slightly to remove from valve body.

1. Check to be sure that stop valve stem is fully seated in plug.
2. Insert stop valve until fully seated beyond retaining ring groove in valve body.
3. Using snap ring pliers, place retaining ring in valve body, making sure that ring is fully seated.
4. Check orientation of stop valve for water flow. (Stop is in the off position when screwdriver slot is vertical).
5. Turn water supply on.

Not for use with Moentrol valves.

I.P.S.

C.C.

VALVE BODY

RETAINER

CLIP

CARTRIDGE

EAR

NOTCHED FLAT

ON STEM

STOP
TUBE

ADJUSTABLE

TEMPERATURE

LIMIT STOP

WASHER

ALWAYS KEEP POINTER UP

HANDLE

KNOB

HANDLE

SCREW

HANDLE

COVER

HANDLE

LEVER

HANDLE SERVICE KIT

RUBBER STOP VALVE