Moen 8713 用户手册

1. With cartridge stem UP, insert  cartridge with ears aligned front to back (illustra-

tion 4).

2. Push the cartridge down by the ears (Illustration 5) until the top of the ears are

flush with the top of the body.

3. Turn notched flat of cartridge stem toward front of sink.  (Note:  for

cross piping installations, see instructions on back page).

4. Replace the clip all the way (Illustration 6).

5. Replace spout.  Push down until it nearly

touches the faucet escutcheon.

6. Screw on retainer pivot nut.  DO NOT CROSS THREAD.

Tighten firmly.

7. Press cartridge stem down.  Holding handle UP, (Illustration 7), hook

handle ring (inside the handle body) into groove on the retainer pivot nut.

8. Swing handle back and forth until it drops down into place.

9. Replace handle screw.  Tighten securely.  Push handle cap down until it snaps

into place.

Your new faucet will give good service for an extended period of time.  Should foreign materials in the system affect its operation, routine repairs can be
easily made.  If your faucet drips from the spout end or leaks up through the handle, follow “Disassembly“ instructions and replace with the cartridge
listed in the Replacement Parts List, on page 4.  If your faucet leaks from either the top or bottom of the spout hub, use the Spout Seal Kit (listed in the
Replacement Parts List) and replace. Re-assemble, following “Reassembly“ instructions.  For proper water flow, aerator must be free of foreign
particles;.  If fow is weak or irregular, unscrew aerator, clean and replace.

Illustration 4

Illustration 7

Remove handle cap, handle screw and handle assembly (see “Disassembly” instructions).  Turn valve stem around

so that the notched flat is turned one half turn or 180˚.  Re-install handle parts (see “Reassembly” instructions).

HOLD

UP

Illustration 5

Illustration 6

EARS

EAR

CLIP