Nortel Networks BCM 1000 用户手册

Chapter 2 Documentation updates for BCM 4.0

N0060603

N0060603

This section should be removed.

This section should be removed and replaced with the following information.

The BCM system is normally initialized prior to shipment. However, if you have to replace the 
hard disk in a standard single-disk system, use this procedure to initialize the BCM software.

After initialization, you must restore the configuration data to the BCM. Use the backup and 
restore utility (BRU) to restore configuration data. Nortel recommends that you maintain a current 
configuration backup. If you do not have a current backup, enter the configuration data manually. 

Perform the following procedures after you replace the hard disk and the system has booted up.

Ensure the Power (LED 1), Temp (LED 9), and Fan (LED 10) LEDs on the BCM main unit are 
lit.

Connect to the BCM system.

Do one of the following:

•

Manually reenter configuration data.

•

Restore system and data information (except Telephony and Registry) from your backup data. 
For information on how to restore data to your system from a backup, refer to the BCM 4.0 
Administration Guide. 

This section should be replaced with the following information: 

Note:  When you replace a hard disk, IP configuration data is lost. The BCM system IP 
address defaults to 10.10.10.1.

Note: Perform a backup only on similar software versions.