Eureka 4490 Series 用户手册

9

To remove HEPA cartridge filters

1.   Push down latch and pull filter cassette back.
2.   Then lift filter up and remove.

To replace HEPA cartridge filters

1.   Place bottom tabs of filter cassette into slots.
2.   Rotate filter toward cleaner.
3.   Push  upward  on  the  latch  to  secure  into 

place.

one  of  the  HEPA  cartridge  filter 

Check the HEPA filters with each disposable dust bag 

change.  Replace  twice  a  year  or  after  every  six  bag 

changes.

  1. Step on handle release.
  2. Lower handle until cleaner is flat on the floor.
  3. Turn the cleaner over so back side faces up.
  4. Lift  cleaner  and  rest  it  against  a  support  or 

counter.

  5. Pull upward on the attached wand portion of the hose 

assembly and remove from the hose retainer.

  6. Check for clogs in the hose retainer and throughout 

the hose assembly.

  7. Use a tool that will not puncture the hose.  Clear any 

debris from the hose retainer or the hose assembly 

that could restrict the air movement.

  8. Flexing the hose may help loosen the clog.
  9. After  the  clog  is  removed  make  sure  the  hose 

assembly,  and  handle  are  reassembled  onto  the 

unit.

10. If the clog is hard to remove, check the brush roll 

area.  Remove the hood and clear the hose inlet in 

the brush roll area.

To remove filters from filter frame.

1.   Push down latch and pull filter frame back.
2.   Then lift filter up and out of filter frame.

To replace filters into filter frame.

1.   Place new filter in filter frame. Place bottom tabs of filter frame 

into slots.

2.   Rotate filter frame toward cleaner.
3.   Push upward on the latch to secure into place.

Use GENUINE EUREKA replacement filters, HEPA , 

part no. 61500; Micron, part no. 60801.

Check the filter each time dust cup is emptied or as needed. 

Replace twice a year as needed.