Hague Quality Water Intl H2500 用户手册

We recommend that you have your local Hague dealer install and service this appliance. 

Warning: Installation of this appliance must conform with state and local plumbing and electrical codes, laws, 
regulations and the instructions provided with this appliance. Failure to install as instructed will void the product 
warranty.

S

S

tep 1

Study the Installation Diagram 

Study the overall installation diagram (See Figure 2) before proceeding, to familiarize yourself 
with the general layout of the appliance. 

tep 2

Check Fit 

Ensure that the complete appliance will fit under the sink. Check all factory fittings

1

 and tubing 

connections. Be sure all locking clips are in place. See steps A through F and the illustrations 
below for tube connection instructions. 

Collet

Cut the tube square. It is essential that the outside 
diameter be free of score marks and that burrs and sharp 
edges be removed before inserting into fitting. 

Insert the locking clip. The locking clip secures the collet in its 
position to prevent an accidental disconnection of the tube. 

The fitting grips before it seals. Ensure that the tube is 
pushed into the tube stop. 

Pull on the tube to check that it is secure. Test the appliance 
before leaving the site or before use. 

Push the tube into the fitting to the tube stop. The collet 
(gripper) has stainless-steel teeth that hold the tube firmly 
in position while the O-Ring provides a permanent  
leak-proof seal. 

To disconnect, ensure that the appliance is depressurized. 
Remove the locking clip. Push in the collet squarely against 
face of the fitting. With the collet held in this position, the tube 
can be removed. The fitting can then be re-used. 

1

The

 RO has been pressure tested. However, due to shipping vibrations, Hague recommends rechecking all 

factory fittings upon installation. 

WaterMax RO Owner’s Manual 

11/11/2009

18