Everpure EV3093-53 用户手册

Everpure, LLC: 1040 Muirfield Drive • Hanover Park, Illinois 60133 • 800.323.7873

In Europe: Toekomstlaan 30 • B-2200 Herentals, Belguim

In Japan: Hashimoto MN Bldg. 7F • 3-25-1 Hashimoto Sagamihara-Shi • Kanagawa 229-1103, Japan

Printed in U.S.A. 

EV3100-91C   FE05

800.942.1153

www.everpure.com

12.   Pour a capful of bleach into the tubing connected in step 11 onto the 3/4” NPT x 3/4” barb connector at the surge tank ball valve and then 

immediately connect the loose tubing end to the 1/2” NPT x 3/4” barb connector installed in step 7.  Fully tighten the remaining tubing clamp 

to secure the tubing onto the connector barb.

13.   Place the high flow filter system into service by opening the inlet water ball valve. Open the surge tank ball valve and allow the surge tank to 

fill for three minutes.

14.   Connect a hose to the high flow filter system activation valve connected to the plated cross. Close inlet valve to the highflow system. Open 

the flush valve and allow the water to drain to waste for five minutes in order to expel chlorinated water from the surge tank or until no 

chlorine odor is detected. Then close the flush valve and open the inlet valve to the high flow system. If new cartridges installed, flush high 

flow system for five minutes. The high flow filter system and surge tank is now in service. 

15.  Inspect the system for any water leakage, tightening all connections as required until no leakage is observed.

16.   After installation of the surge tank, it will be necessary to close the surge tank ball valve prior to removing cartridges from the pre-filter or 

high flow filter system. 

No routine servicing of the surge tank is required under normal operating conditions although periodic sanitizing (annual) is recommended. The 

only servicing of the surge tank occurs if the internal air bladder pressure (excluding water pressure) is not 20±2 psi when empty. A conventional 

tire valve is provided at the top of the extra capacity surge tank and near the bottom of the standard surge tank to monitor and adjust the internal 

pressure.

You have just purchased one of the finest water treatment units made. As an expression of our confidence in Everpure products, this product is warranted 

against defects in material and workmanship to the original end-user when installed in accordance with Everpure specifications. The warranty period 

commences from the date of purchase and is administered as follows:
 

The unit must be used in operating conditions that conform to Everpure’s recommended design guidelines. This warranty will not apply if the unit has been 

modified, repaired or altered by someone not authorized by Everpure. 
If a part described above is found defective within the specified period, you should notify Everpure technical service at the phone number listed below. 

warranty terms of the existing system.
We are not responsible for damage caused by accident, fire, flood, freezing, Act of God, misuse, misapplication, neglect, oxidizing agents (such as chlorine, 

ozone, chloramines and other related components), alteration, installation or operation contrary to our printed instructions, or by the use of accessories or 

components which do not meet Everpure’s specifications. Refer to the specifications section in the Installation and Operating manual for approved application 

parameters.
Our product performance specifications are furnished with each water treatment unit. TO THE EXTENT PERMITTED BY LAW, EVERPURE DISCLAIMS ALL 

IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION WARRANTIES OF MERCHANTABILITY AND FITNESS FOR PARTICULAR PURPOSE; TO THE EXTENT 

REQUIRED BY LAW, ANY SUCH IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE PERIOD SPECIFIED ABOVE FOR THE ENTIRE WATER TREATMENT 

UNIT. As a manufacturer, we do not know the characteristics of your water supply or the purpose for which you are purchasing this product. The quality of 

water supplies may vary seasonally or over a period of time, and your water usage rate may vary as well. Water characteristics can also differ considerably 

if this product is moved to a new location. For these reasons, we assume no liability for the determination of the proper equipment necessary to meet your 

requirements, and we do not authorize others to assume such obligations for us. Further, we assume no liability and extend no warranties, express or implied, 

for the use of this product with a non-potable water source or a water source which does not meet the conditions for use described in the owner’s guide or 

performance data sheet for this product. OUR OBLIGATIONS UNDER THIS WARRANTY ARE LIMITED TO THE REPAIR OR REPLACEMENT (AT EVERPURE’S 

DISCRETION) OF THE FAILED PARTS OF THE WATER TREATMENT UNIT, AND WE ASSUME NO LIABILITY WHATSOEVER FOR DIRECT, INDIRECT, INCIDENTAL, 

CONSEQUENTIAL, SPECIAL, GENERAL OR OTHER DAMAGES. 
Some states do not allow the exclusion of implied warranties or limitations on how long an implied warranty lasts, so the above limitation may not apply to 

you. Similarly, some states do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This 

warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Consult your telephone directory for your local 

independently operated Everpure dealer, or write Everpure for warranty and service information.